400-027-8848Chinese/English
Position:HOME > PRODUCT > Relay Protection and Mutual Inductor Test Device

HZJB Three & Six Phase Relay Protection Tester

Application:

HZJB series microcomputer relay protection tester is a new small microcomputer relay protection testing instrument, manufactured referencing DL/T624-199 microcomputer relay protection test device technology, listening to the views of users, summarizing the advantages and disadvantages of the same domestic products, using modern advanced microelectronic technology and device.

Features:

Satisfy all on-site test requirements.

Technical indicators fully meet the DL/T624-1997 “microcomputer relay protection test device technology” standard issued by the Ministry of electric power.

This device Windows XP system with recovery function, avoid system crash caused by the illegal shutdown or misuse.

Main control board uses DSF+FPGA structure, 16 bit DAC output, the basic wave can produce weekly 2000 points of high density sine wave, greatly improve the waveform quality, and improve the accuracy of the test instrument.

The classic Windows XP operation interface, the man-machine interface is friendly, the operation is simple and quick.

Amplifier using high fidelity linear power amplifier, both to ensure the accuracy of the small current, but also to ensure the stability of the large current.

With GPS synchronous test function. The device can be built in GPS synchronous card, connected with the PC machine through the RS232 interface, to achieve synchronous test switch of two test sets in different places.

Specification:

 

Model

Parameters

HZJB-421

HZJB-426

AC Current

3 x (0~40A/phase)

6 x (0~30A/phase)

DC Current

3 x (0~±10A/phase)

6 x (0~±10A/phase)

AC Voltage

4 x (0~120V/phase)

6 x (0~125V/phase)

DC Voltage

4 x (0~±160V/phase)

6 x (0~±150V/phase)

Accuracy

0.2%

0.5%

Switch Quantity

8 pairs of input, 4 pairs of output

Auxiliary Output

Auxiliary DC source: 220VDC/110VDC automatically output simultaneously, can be used to  protect power supply, without the need to set and adjust the software. Power: single channel not less than 110VA.

Remark

 Can equip with a notebook computer to operate

 Windows XP system, embedded industrial control computer